From Erlang Community

Revision as of 17:02, 31 July 2006 (edit) Massemanet (Talk | contribs) ← Previous diff		Current revision (17:13, 31 July 2006) (edit) (undo) Massemanet (Talk | contribs)
(2 intermediate revisions not shown.)
Line 1:		Line 1:
		+	===caveat===
		+	unless you really know what you're doing, you'll be better off using a linked-in driver or a port.
		+	===steps===
	:1. run configure		:1. run configure
	:2. add your bifs to erts/emulator/beam/bif.tab		:2. add your bifs to erts/emulator/beam/bif.tab
Line 22:		Line 25:
	</pre>		</pre>
	:6. run make; make install		:6. run make; make install
		+	===notes===
		+	*steps 0-3 need only be done once.
-	steps 0-3 need only be done once.	+	*note that if you add
-		+
-	note that if you add	+
	<pre>		<pre>
	bif re:grep/2		bif re:grep/2

---

Current revision

[edit] caveat

unless you really know what you're doing, you'll be better off using a linked-in driver or a port.

[edit] steps

1. run configure

2. add your bifs to erts/emulator/beam/bif.tab

bif re:grep/2 bif re:compile/1

3. create a C file

erts/emulator/beam/erl_bif_re.c

4. add your C file to erts/emulator/<arch>/Makefile

RUN_OBJS = $(OBJDIR)/erl_bif_re.o \

5. implement your bifs by stealing bits from existing erl_bif_*.c files

BIF_RETTYPE re_grep_2(BIF_ALIST_2){
  Eterm result;
  result = magic_function(); 
  BIF_RET(result);
}

6. run make; make install

[edit] notes

• steps 0-3 need only be done once.

• note that if you add

bif re:grep/2

to bif.tab there should be a erl_bif_re.c that implements

BIF_RETTYPE re_grep_2(BIF_ALIST_2);